AKG C-451 B

Apr 1, 2002 12:00 PM, BY BARRY RUDOLPH

Polls


Mix Regional

The Mix Regional section for Mix's September 2014 issue focuses on Miami. Send us your studio news: updates, sessions, new rooms, plus club performances and installations. Let the Mix audience know what is going on! Send photos and descriptions to mixeditorial@nbmedia.com.

Although the mic was designed as an homage to its famed ancestry, I'm glad AKG chose not to call the new C-451 B a reissue microphone. The C-451 B is an entire rethinking of the classic C-451 E/CK-1 capsule design, and it sounds better than the original — the result of improved specs, modern componentry and updated construction techniques.

A LITTLE HISTORY

Made from the late '60s through the mid-'80s, the original AKG C-451 C Condenser Modular System (CMS Series) was a best-selling “chameleon” of a mic. It was designed to be adaptable to nearly any purpose; it could be outfitted with any of a whole system of modular components — such as screw-on capsule attenuator pads, extension tubes and swivels — that greatly increased its versatility. The original mic used the N-46E dual-AC power supply that supplied 12-volt phantom power and had a two-position, bass roll-off filter switch. As I found out by accident in my distant past as a second engineer, the mic would accept up to 52-volt phantom powering without smoking. The original, externally biased CK-1 capsule had an extremely low mass, making the mic insensitive to handling noise and a favorite for handheld radio and TV use.

For AKG, the C-451 C (the “C” suffix indicates a DIN connector; the “E” designates a standard XLR output) was the first solid-state condenser mic using the then-new Field Effect Transistor (FET) instead of a tube. It replaced both the great-sounding AKG/Norelco C 60 pencil condenser, which used an AC701K tube, and the C-61 with its miniature RCA 7586 Nuvistor tube. With the C-451 EB came a switchable -12dB/octave highpass filter with flat/75/150Hz positions. Much later, the C-452 EB arrived, which is the same but runs on 48-volt phantom only. Sadly, for economic reasons, AKG discontinued the CMS Series and the CK-1 capsule in 1994.

WHAT'S NEW?

AKG's R&D department gathered 12 of what was considered the creme de la creme of vintage CK-1 capsules from around the world to measure and determine their original acoustic properties. The new C-451 B capsule uses a backplate electret, self-polarized design with a three-micron, gold-sputtered Mylar diaphragm suspended just 35 microns from the printed-circuit backplane. The new capsule has the same cardioid polar pattern that the CK-1 has.

Once the CK-1 was reinvented, AKG completely updated the mic's body with Surface Mount Technology (SMT) components on a miniature printed-circuit board and gold-plated XLR and capsule connectors. The old mics were laboriously hand-soldered and prone to intermittents — a well-known fact among live sound engineers who shun their use on the road. One new design criteria for the new C-451 E is passing AKG's dreaded drop test, which simulates a 6-foot fall from drum overhead mic stands. This test is repeated six times on each of a group of mics that are randomly selected from the production line.

To make the mic even more rugged, the new capsule is permanently attached to the C-451 B preamp body. A one-piece mic is a welcome feature of the C-451 B, especially to any engineer who, in the middle of a session in a dimly lit studio, has struggled to attach the CK-1 onto the old C-451/452 bodies properly, without cross-threading those very fine, Swiss watch-like threads! However, I do miss the C-451/452's capsule swivel adapters, which were great for sneaking around drum kits…

One thing I don't miss is the need to insert screw-on capsule mic attenuator pads like the ones the old C-451/452 EB mics had. Right on the C-451 B body, near the bass roll-off switch, are -10 and -20dB capsule attenuation switches. Also, both the pad and HP filter switches are improved over the original switches. The new switches are easy-to-see red, and they seem to be better made and easier to change with the tip of a ball-point pen. The old EB's roll-off switches often broke, stuck or disappeared inside the mic body, making it impossible to know (by looking at them) how they were set. Cosmetically, the C-451 B looks similar to the old mics, with sandblasted, all-metal, nickel-plated housing, and engraved wording and symbols. Often, on late '80s-vintage C-451 E mics, the decals (without engraving) wore off.

THE SOUND!

In my A/B tests, I found the C-451 B's new transformerless output improved LF reproduction, especially at higher SPLs. I also noticed more output level than the C-451 E, C-451 EB, C-452 E and C-452 EB. Without going into explicit detail, all the mics sounded great, but overall, the C-451 B is simply more pleasant-sounding than the others. It's warmer than the C-452s, with a better bass roll-off sound, and the bottom end is cleaner than the original. I like the LF sound of the original C-451s, too — just as I like using vintage Neve modules for the sonics of those transformers. The C-451 B still uses the FET design, so everything you'd use the old mics on sounds the same — only better.

You can buy the C-451 B in two ways. As a single mic, it comes with a clip/stand adapter and windscreen in a zippered bag.

For this review, I received a stereo pair of two computer-matched microphones. They come with two clips, two windscreens and the H 50 stereo-mounting bar — all in a foam-lined carrying case. “Matched” is an understatement! All new C-451 Bs come with individually measured frequency response (20 to 20k Hz, ±1.5 dB) curve plots. My two mics' curves are identical; in fact, I can place the two tissue-paper charts (shown in the figure) on top of each other and see no differences. AKG uses a computer database comprising all of the frequency response results from a production run of mics. The computer comes up with the best matching pair: Both frequency response and sensitivity measurements must be within ±0.5 dB of each other.

IN THE STUDIO

The most popular studio applications for the C-451/452 have always been drum kits, overheads and acoustic guitar. Small-diaphragm mics excel at accurately reproducing the percussive transients of these instruments. For drums, I always liked the C-451 E on hi-hat and/or snares. Both jobs usually require the attenuator pad, and it is so nice not to have to take the mic down to screw in the -20dB pad when the -10dB pad wasn't enough! The C-451 B, with an increased SPL rating of 135 dB (no pad), would have been fine without a pad on the quieter songs. Even without EQ, both snare drums and hi-hats sound crisp, sharp and “open.” The cardioid pickup pattern is not too tight, which provides plenty of ambience for a close-miked instrument, while I can hear more drummer subtleties such as grace notes and stick drags.

The H 50 stereo bar is just the ticket for X/Y or close-spaced cardioid miking of percussion instruments like congas or marimba. In live sound use, I like eliminating one mic stand in a usually crowded percussion-miking setup.

Acoustic guitar recording is exactly the same as with the old mics, except the C-451 B produces tighter, cleaner lows. I also had fewer problems when my guitar player unexpectedly went from quiet finger-picking to full strumming — the mic and recording chain didn't instantly distort. I like the presence of miking close on guitars, but proximity can be a problem. On a Gibson jumbo-body guitar, I put the mic about six inches over the soundhole, aimed toward the bridge, and I used the 150Hz roll-off. Sometimes I used the 75Hz position and rolled off with an equalizer when I needed a song/production/arrangement-specific LF contour. The C-451 B's high-frequency lift is pleasing for acoustic guitar recording — much better than winding on a lot of EQ.

The AKG C-451 B reinforces my fond memories of using the venerable C-451 E with the same but improved sound, and without the old, impractical quirks. The C-451 B retails at $549, or $1,250 for a matched stereo pair.

Thanks to Tom and Nate Murphy for letting me raid their fine microphone cabinet and use their new SSL 9000 J console at Track Record, their North Hollywood studio. Also, thanks to Dan and Eric at LAFX Studios here in NoHo and to engineer/producer Alan Parsons for all their help.

AKG Acoustics, 914 Airport Center Drive, Nashville, TN 37217; 615/620-3800; fax 615/620-3875; www.akgusa.com.


Barry Rudolph is an L.A.-based recording engineer. Visit his Web site at www.barryrudolph.com.






Acceptable Use Policy
blog comments powered by Disqus

Mix Books

Modern Recording and Mixing

This 2-DVD set will show you how the best in the music industry set up a studio to make world-class records. Regardless of what gear you are using, the information you'll find here will allow you to take advantage of decades of expert knowledge. Order now $39.95

Mastering Cubase 4

Electronic Musician magazine and Thomson Course Technology PTR have joined forces again to create the second volume in their Personal Studio Series, Mastering Steinberg's Cubase(tm). Edited and produced by the staff of Electronic Musician, this special issue is not only a must-read for users of Cubase(tm) software, but it also delivers essential information for anyone recording/producing music in a personal-studio. Order now $12.95

Newsletters

MixLine

Delivered straight to your inbox every other week, MixLine takes you straight into the studio, with new product announcements, industry news, upcoming events, recent recording/post projects and much more. Click here to read the latest edition; sign up here.

MixLine Live

Delivered straight to your inbox every other week, MixLine Live takes you on the road with today's hottest tours, new sound reinforcement professional products, recent installs, industry news and much more. Click here to read the latest edition; sign up here.

[an error occurred while processing this directive]

The Wire, a virtual press conference offering postings of the latest gear and music news, direct from the source. Visit the The Wire for the latest press postings.