Ingram Engineering MPA685 Microphone Preamp Review

Sep 1, 2011 9:00 AM, By Barry Rudolph



Education Guide

Mix is gearing up to present its longstanding annual Audio Education Guide in its November 2014 issue. Want to have your school listed in the directory, or do you need to update your current directory listing? Add an image, program description, or a logo to your listing! Get your school in the Mix Education Guide 2014.

Noise vs. Impedance with and without X-former

Noise vs. Impedance with and without X-former

The first test was a quick shootout to see where the MPA sits compared to other well-known mic pre’s. I built a special four-way mic splitter for the occasion using a Jensen JT-MB-E transformer.

My first A/B/C test compared the MPA to GML 8302 and Neve 1272 mic pre’s. I used a Royer 121 ribbon mic on a Fender Champ amp to record a clean electric guitar performance to Pro Tools|HD9 at 96 kHz. The MPA was set to high impedance (2.5k), the +6 gain position, with the output full up, while the GML and Neve were both set to 50 dB.

I found the MPA to have a lot of available gain, but at first it sounded thin compared the other preamps. Selecting the Ingram’s low-impedance (600-ohm) position changed that right away. The lower-impedance position required more gain up at the +9 position. Now the MPA sound stood right up and was clear, fat and present-sounding. The GML sounded as expected, very clean and clinical, while the Neve was warm, thick and a little dark compared to the others.

For loud crunch sounds, I changed guitar amps but kept the Royer. I was surprised to hear the MPA (still on low impedance) holding up perfectly with gain set down to +1 and sounding big, open, clear and loud. The GML, at 35dB gain, became slightly midrangy and “barky,” while the Neve, also at 35 dB, got “spongier”—softer sounding compared to the clean electric guitar tests. Unlike the GML or Neve pre’s, the MPA didn’t change in sound character with the increased input level.

I took the MPA685 solo for a vocal session using my MXL Revelation tube mic set to cardioid. In general, compared to my other preamps, I found the MPA to be more transparent during peak level moments. One of these moments is just at the point where my loud singer hits his stride right up close to the mic. All preamps sound nasty when overloaded, but the MPA is more forgiving; it sounds better at those moments.

Switching impedances from high to medium to low steps the output level down, respectively. Depending on the mic, I found that I had to bump the gain up two to four clicks when switching to a lower-impedance setting to obtain the same recording level. The sound quality for the same mic is also different; the low-impedance setting, along with more mic gain, produces a warmer and more intimate sound.

Moving to medium seemed to change my singer’s mic presence very slightly, with a change in the mic’s LF character. Use the high-impedance position and the mic is loaded more like a typical bridging input of a modern mic pre.

Running five or more extras clicks of gain and winding back the output level will produce a “hotter” sound by way of a subtle increase in IM, and, as pleasant as this sounds sometimes, it is level-dependent and inconsistent.

I tried a stereo recording of a Martin D15 using a Rode NT4 X/Y stereo condenser. The two channels of the MPA matched exactly in level and sound. I swapped the L/R outs of the mic between channels to check this. This time, the tonal change between high and low impedance was subtle—just slightly warmer in low but more articulated sounding when using the high-impedance position; it just depends on what you’re looking for. For the song I was working on, I found the low impedance and about +3 to +5 on the gain rotary with the 70Hz HPF was best.

I tried the MPA’s DI path and again found loads of gain. The front panel “chicken head” gain knob was now at the -7 position for a stock Fender Jazz bass with passive pickups. The sound was clear and precisely the way this bass sounds under ideal conditions. With this much gain available, guitars with low-output piezoelectric pickups would be no problem to amplify with this excellent-sounding DI.

The MPA685 allows you to rediscover your whole mic collection by way of its three input impedance choices, remarkable dynamic range and its huge reservoir of gain. Add the super-DI path, and you have an excellent, professional and worthwhile tool ready for any recording task.

Barry Rudolph is an L.A.-based recording engineer.

Click on the Product Summary box above to view the MPA685 product page.

Click on the Product Summary box above to view the MPA685 product page.

Acceptable Use Policy
blog comments powered by Disqus

Mix Books

Modern Recording and Mixing

This 2-DVD set will show you how the best in the music industry set up a studio to make world-class records. Regardless of what gear you are using, the information you'll find here will allow you to take advantage of decades of expert knowledge. Order now $39.95

Mastering Cubase 4

Electronic Musician magazine and Thomson Course Technology PTR have joined forces again to create the second volume in their Personal Studio Series, Mastering Steinberg's Cubase(tm). Edited and produced by the staff of Electronic Musician, this special issue is not only a must-read for users of Cubase(tm) software, but it also delivers essential information for anyone recording/producing music in a personal-studio. Order now $12.95



Delivered straight to your inbox every other week, MixLine takes you straight into the studio, with new product announcements, industry news, upcoming events, recent recording/post projects and much more. Click here to read the latest edition; sign up here.

MixLine Live

Delivered straight to your inbox every other week, MixLine Live takes you on the road with today's hottest tours, new sound reinforcement professional products, recent installs, industry news and much more. Click here to read the latest edition; sign up here.

[an error occurred while processing this directive]

The Wire, a virtual press conference offering postings of the latest gear and music news, direct from the source. Visit the The Wire for the latest press postings.